win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Novice driller needs layout help with a Fury Pearl  (Read 1138 times)

leftyinsnellville

  • Hero Member
  • *****
  • Posts: 2345
Novice driller needs layout help with a Fury Pearl
« on: October 24, 2008, 11:34:33 PM »
The FP I bought has a less than 2" pin.  Thinking that it would be best to go with the drilling that Brunswick suggests for a short pin, I chose the maximum hook and arc layout pattern. (see link)

http://www.brunswickbowling.com/uploads/L7/cc/L7ccVnpAUP6FRGMWVu0Bbw/Advanced-Drilling-Instructions---Symmetric--Asymmetric---December07.pdf

That pattern indicates 4 1/2" between pin and PAP with the pin under ring and the CG kicked out slightly.  As my PAP is 4 1/8" horizontal and 1/2" up, the layout ends up with the pin under middle if I keep the CG in the suggested range.  

Is it better to have the pin the proper distance from PAP or to have the pin positioned properly in relation to the finger grips?

Thanks in advance for you suggestions.
--------------------
220...221...whatever it takes.
Logged

 

dizzyfugu

  • Hero Member
  • *****
  • Posts: 7606
Re: Novice driller needs layout help with a Fury Pearl
« Reply #1 on: October 25, 2008, 07:54:36 AM »
Always use the PAP as primary reference. The finger holes as reference do not tell you much, the only "problem" sometimes is to place the pin and/or CG in a drill-safe position.

I think with your PAP the pin will end up under the bridge (medium PAP as reference) and the CG slightly to the right of the mid line, under the grip center with a 2" pin. If you want some (more) flip or later reaction, drill the thumb hole a bit deeper to reduce weight in that area.

Just my 2 cents, not an expert, but what I'd suggest
--------------------
DizzyFugu - Reporting from Germany

Confused by bowling?
Check out BR.com's vault of wisdom: the unofficial FAQ section



Edited on 10/25/2008 8:18 AM
Logged
DizzyFugu ~ Reporting from Germany

leftyinsnellville

  • Hero Member
  • *****
  • Posts: 2345
Re: Novice driller needs layout help with a Fury Pearl
« Reply #2 on: October 25, 2008, 08:05:11 AM »
Thanks Diz!
--------------------
220...221...whatever it takes.
Logged

Russell

  • Hero Member
  • *****
  • Posts: 5121
Re: Novice driller needs layout help with a Fury Pearl
« Reply #3 on: October 25, 2008, 09:06:30 AM »
dizzy is dead on here....PAP to pin distance is important and then the rise from grip center determines over/under the fingers.
--------------------
http://www.myspace.com/rlrussell

The artist formerly known as "jabroni"
Logged
Pages: [1]
« previous next »