Author Topic: drilling for super flippy backends (Read 1743 times)

Next Level PS · « **on:** September 23, 2003, 08:20:22 AM »

I need a suggestion 37Ft shoot with flippy backends, medium to high revs I was thinking of PEARL SONIC X with 5 X 6 drilling with mass bias deep in track area. I might need a small/ deep X-hole in track area what do you guys suggest.
--------------------
www.bowlritelanes.com

Jeffrevs · « **Reply #1 on:** September 24, 2003, 07:38:25 AM »

VII
with the little .020 diff on the Sonics, and your rev rate, a 5 label drill (5x6) would work. I play on a 35 ft screaming backend house and my Sonic solid works with a 4x4. Yes, I'm only medium revved, but still. Both balls would work, it all depends on if you like pearls or solids better.
--------------------
JEFF
"How do you chop the 10 off the 6 ?!?!?!"

charlest · « **Reply #2 on:** September 24, 2003, 08:29:01 AM »

quote:
I need a suggestion 37Ft shoot with flippy backends, medium to high revs I was thinking of PEARL SONIC X with 5 X 6 drilling with mass bias deep in track area. I might need a small/ deep X-hole in track area what do you guys suggest.
--------------------
www.bowlritelanes.com

37 feet? Depends on how heavy that 37 feet is oiled. If the SOnic-X pearl will handle that much oil, and with its built-in length, I wonder if a 2x3 or a 2x4 (or even 2x5; I've had some success with that one and I'd say I have medium to medium-high revs) drilling, dependent on the pin-CG distance, wouldn't be more appropriate to enable a high rev bowler to handle very strong backends???
--------------------
"Those who do not remember history are doomed to repeat it."

Author Topic: drilling for super flippy backends (Read 1743 times)

Next Level PS

drilling for super flippy backends

Jeffrevs

Re: drilling for super flippy backends

charlest

Re: drilling for super flippy backends