Author Topic: Dual Angle layout help (Read 3325 times)

BowlingforSoup · « **on:** June 01, 2014, 10:51:28 PM »

I have a Layout that I really like on an asymmetrical ball.Its 65 x 3 3/8 x 25.Its off Mos recommended layouts for tracks less than 12 degrees of tilt.If I wanted to drill a symmetrical ball like this what would angles and pin to pap be.Any help appreciated.

batbowler · « **Reply #1 on:** June 02, 2014, 10:33:46 AM »

Mo also has layouts for Symmetrical core as well as Asymmetrical. Use the symmetrical layout that matches the layout you like. If it's the control layout for the asymmetrical, use the control layout off the symmetrical layout sheet! Just my $.02, Bruce

tommymo · « **Reply #2 on:** June 02, 2014, 05:31:31 PM »

The drilling you stated was off of Mo's old drilling sheet. He has since released a set of drillings for symmetrical balls. Pin to pap, val angle, balance hole location and surface are the biggest concerns when drilling symmetricals.

http://wiki.bowlingchat.net/wiki/images/a/a4/Radical_Symmetrical.pdf

BowlinStr8t · « **Reply #3 on:** June 02, 2014, 10:18:00 PM »

Usually, going to sym. from assym.--you want to go with longer pin to pap distances. Your assym. drilling allows the ball to store energy and then be stronger on the back. IMO you would have to go with a longer pin distance to get the sym. to do the same thing.

Author Topic: Dual Angle layout help (Read 3325 times)

BowlingforSoup

Dual Angle layout help

batbowler

Re: Dual Angle layout help

tommymo

Re: Dual Angle layout help

BowlinStr8t

Re: Dual Angle layout help