win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Assymetrical balls and core laydown  (Read 1419 times)

Doc Hollywood

  • Hero Member
  • *****
  • Posts: 1177
Assymetrical balls and core laydown
« on: April 17, 2005, 02:00:41 AM »
Here is another question for you all.

When you have a stronger player with a good match up of speed and rev rate and low axis tilt that does not require help getting the ball into a roll where would you keep the side weight at?

Same question to a player but has high tilt?
--------------------
Doc
Owner and Inventor of
DOC'S MAGIC BOWLING BALL ELIXIR
For more information click on the link below
http://home.comcast.net/~docsmagic/
or message me at:
http://Doc65@aol.com
Logged

 

Brickguy221

  • Hero Member
  • *****
  • Posts: 9918
Re: Assymetrical balls and core laydown
« Reply #1 on: April 17, 2005, 10:28:07 AM »
Doc, I believe you do or used to bowl with Rick (tenpinspro). Ask him as I'm sure he can answer your question.

--------------------
Owner of a 129 game and a 486 series bowled with a Brunswick Impulse Zone.

Edited on 4/17/2005 10:23 AM
Logged
"Whenever I feel the urge to exercise I lie down until the feeling passes away"

T-GOD

  • Hero Member
  • *****
  • Posts: 2141
Re: Assymetrical balls and core laydown
« Reply #2 on: April 18, 2005, 07:02:15 AM »
Less tilt will usually need more side weight. More tilt, less side weight. =:^D
Logged

DP3

  • Hero Member
  • *****
  • Posts: 6093
Re: Assymetrical balls and core laydown
« Reply #3 on: April 18, 2005, 11:53:45 AM »
I am a power player(two handed, albeit)...but my revrate is 510rpms with a speed of about 18-18.4mph(on avg) and a tilt of about 53degrees(All Ebonite Bowlers Map calculations) and when drilling balls whether I have a weighthole or not, I like to keep my static weights around 1/4 positive side and between 1/4 and 1/2 positive finger weight, unless I am looking for a hook/stop type of reaction, then I'll put the weighthole inside of my VAL(outside the VAL usually flares over the hole for me) and reduce the sideweight to 1/2 negative(I've done this in a Red Executioner and Hex Revmaster and they both work great).
--------------------
-DP3
...
Logged

blockhater

  • Full Member
  • ***
  • Posts: 188
Re: Assymetrical balls and core laydown
« Reply #4 on: April 25, 2005, 12:41:14 PM »
Static weights do not matter. Aside from making the ball legal and positioning balance holes it does not matter where you put the CG. This has been proven by Brunswick with Throwbot.

If you are drilling a ball with lots of assymetry in the core then you will need to consider where this 'mass bias' (or PSA, RAD, bomb etc etc etc) is located. As it is approximately in a line with the pin and CG you will then have to consider the CG position, but only as a secondary consideration.

The degree layout system need only be considered for assymetrical balls.
Logged
Pages: [1]
« previous next »