win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Unleashed drilling  (Read 1328 times)

Re-Evolution

  • Hero Member
  • *****
  • Posts: 2080
Unleashed drilling
« on: July 14, 2004, 08:24:51 PM »
I just ordered an Phenom Unleashed with a 3-4" pin and would like suggestions on a drilling pattern for my style.

Me:
15-16mph
low medium revs
60-75 degrees of axis rotation
PAP over 5 1/2" up 1"
Axis tilt 9°-10°

Preferred line is 13-15 arrow 6-10 at break point

Pin above fingers works best for me the only time I ever tried pin under I had problems with rolling over the thumb hole, flaring over the middle finger is not a problem since I track about 2" inches from fingers but only 1/2" from thumb.

Condition:
load - Med to medium/heavy
length - 42'
--------------------
STORMIN1



Edited on 7/17/2004 12:47 PM
Logged

 

omegabowler

  • Hero Member
  • *****
  • Posts: 1470
Re: Unleashed drilling
« Reply #1 on: July 15, 2004, 05:17:05 PM »
for backend play, I have mine drilled pin 3" above midline, 4" from pap and the the Mb at 4.25 from pap. box finish. this gives me control on the backend with a nice hard turn. I like this n med-heavy longer patterns. I have had some great games on PBA Pattern B with this ball.
--------------------
"deserves got nothing to do with it."
-- William Munny
Logged
"deserves got nothing to do with it."
-- William Munny

Re-Evolution

  • Hero Member
  • *****
  • Posts: 2080
Re: Unleashed drilling
« Reply #2 on: July 17, 2004, 12:57:09 PM »
added tilt
I used my PAP to find it using an angle finder program.

--------------------
STORMIN1

Logged

Re-Evolution

  • Hero Member
  • *****
  • Posts: 2080
Re: Unleashed drilling
« Reply #3 on: July 17, 2004, 02:30:01 PM »
What is the purpose of the balance hole being pitched and what determines the direction to pitch it?
By the way it isn't a lot of work finding tilt the way I did only a few seconds on the computer enough time to draw out 2 line on a grid.
--------------------
STORMIN1

Logged

Re-Evolution

  • Hero Member
  • *****
  • Posts: 2080
Re: Unleashed drilling
« Reply #4 on: July 17, 2004, 03:29:05 PM »
For starters I am not a kid I am 33 and have an IQ of 147 so don't assume that just because I am not a drilling guru that I am a kid and/or dumb.

Secondly my method is accurate also.

I used your method for comparison and it comes out the same.
Track diameter 11"
13.5-11=1.5*6.67=10.005



--------------------
STORMIN1

Logged
Pages: [1]
« previous next »