BallReviews

General Category => Drilling & Layouts => Topic started by: BrunsNick on August 29, 2007, 07:46:20 PM

Title: Vent Hole Tutorial - vid/article
Post by: BrunsNick on August 29, 2007, 07:46:20 PM

The how and why at www.askthebowler.com
--------------------
Nick Smith ... A.K.A. Les Badderâ„¢
Brunswick -=- PBA 03-07
http://www.BrunsNick.com
http://www.AskTheBowler.com
http://www.BigBapparel.com
Friends don't let friends drink the Kool-Aid!

Title: Re: Vent Hole Tutorial - vid/article
Post by: BrunsNick on August 30, 2007, 12:17:07 PM

Wouldn't hurt to try!
--------------------
Nick Smith ... A.K.A. Les Badderâ„¢
Brunswick -=- PBA 03-07
http://www.BrunsNick.com
http://www.AskTheBowler.com
http://www.BigBapparel.com
Friends don't let friends drink the Kool-Aid!

Title: Re: Vent Hole Tutorial - vid/article
Post by: Sawuser on September 01, 2007, 08:13:41 PM

Might be a stupid question, but why don't you just use a vented slug? I make my own & it's very simple requiring no hole to be drilled in the ball. Just curious.
--------------------
Righty
Think about it!

The trouble with our liberal friends is not that they are ignorant, but that they know so much that isn't so. Ronald Reagan

Title: Re: Vent Hole Tutorial - vid/article
Post by: BrunsNick on September 01, 2007, 09:39:51 PM

I could, but not everyone uses a slug. Also, debris or sludge from ball resurfacing can get crammed into the run channel. I tend to use 5 min epoxy for slugs all the way around, to insure a solid installation.
--------------------
Nick Smith ... A.K.A. Les Badderâ„¢
Brunswick -=- PBA 03-07
http://www.BrunsNick.com
http://www.AskTheBowler.com
http://www.BigBapparel.com
Friends don't let friends drink the Kool-Aid!

Title: Re: Vent Hole Tutorial - vid/article
Post by: Sawuser on September 01, 2007, 10:52:50 PM

Makes sense. Thanks.
--------------------
Righty
Think about it!

The trouble with our liberal friends is not that they are ignorant, but that they know so much that isn't so. Ronald Reagan