BallReviews

General Category => Drilling & Layouts => Topic started by: johns811 on January 01, 2005, 11:29:36 AM

Title: Viz a ball drilling help needed.
Post by: johns811 on January 01, 2005, 11:29:36 AM

I got my dad a Cleveland Indians Viz a ball for 10 pins. Following the Brunswick drill instructions the line where the two images come together will cut the ball in half (finger half, thumb half) in the middle of the grip. I think the ball would look better if I rotated in 90 deg so the line went approx thru the bridge and thumb hole. This way two images will be on the left and right side. Is ok to do this to a Viz-a-ball and will it adversely effect the ball in any way?

Thanks
John

Title: Re: Viz a ball drilling help needed.
Post by: TheBowlingKid25 on January 01, 2005, 07:53:28 PM

I dont think it really matters much. If its just a line where the graphics meet it shouldnt do any harm. I dont think there is a wrong way to drill those balls. Anyone else wanna chime in if I'm wrong?
--------------------
16 years old, and proud of it! Still not mature either!

Title: Re: Viz a ball drilling help needed.
Post by: DP3 on January 01, 2005, 07:53:48 PM

That's fine too.  I've had a vis-a-ball drilled that way, makes no difference.
--------------------
-DP3

Title: Re: Viz a ball drilling help needed.
Post by: Fatboy8 on January 01, 2005, 08:12:42 PM

My viz a ball is drilled with the line through the fingers, no problems whatsoever.
--------------------
It seems one man's struggles solve another man's problems.....