BallReviews

General Category => Drilling & Layouts => Topic started by: Lillen on October 20, 2009, 04:50:26 PM

Title: Wanna try a short Pin - Pap layout....
Post by: Lillen on October 20, 2009, 04:50:26 PM: Let say 2 1/2 x 2 and I have two candidates for the job, a Dynothane Elements ZR40 and a Track Tantrum..

Which one do you guys think would be the most suited for the job?

Thanks..
--------------------
-------------------
www.psbowling.se/
www.dteracing.se
http://www.festis.se/orange.html
Title: Re: Wanna try a short Pin - Pap layout....
Post by: dizzyfugu on October 21, 2009, 07:07:30 AM: Depends on what you want to achieve... I found that such a layout is VERY rolly, so a ball with a higher RG is a good base (saving energy for the back end), unless you want it as a smooth roller for long and heavy oil. Some good RG. diff. is also not wrong - too little, and the ball won't turn much at all.

From both balls, I'd give the Zr40 a try, and adjust the surface if needed. The Tantrum is more modern, but with its low RG I'd only favor it if you were really a low revs/high speed player. The Zr40 - by its numbers - seems to offer more versatility and room for tuning here.
--------------------
DizzyFugu - Reporting from Germany

Confused by bowling? Check out BR.com's vault of wisdom: the unofficial FAQ section (http://"http://www.ballreviews.com/Forum/Replies.asp?TopicID=74110&ForumID=16&CategoryID=5")
Title: Re: Wanna try a short Pin - Pap layout....
Post by: Lillen on October 21, 2009, 07:23:24 AM: Danke schÃ¶n Dizzy...
--------------------
-------------------
www.psbowling.se/
www.dteracing.se
http://www.festis.se/orange.html
Title: Re: Wanna try a short Pin - Pap layout....
Post by: dizzyfugu on October 23, 2009, 02:15:19 AM: VarsÃ¥god! (???)

Hope it helps a bit - just personal opinion!
--------------------
DizzyFugu - Reporting from Germany

Confused by bowling? Check out BR.com's vault of wisdom: the unofficial FAQ section (http://"http://www.ballreviews.com/Forum/Replies.asp?TopicID=74110&ForumID=16&CategoryID=5")