BallReviews

General Category => Drilling & Layouts => Topic started by: Myser on December 14, 2006, 05:27:43 AM

Title: Weight hole to move track
Post by: Myser on December 14, 2006, 05:27:43 AM

Hey thanks for reading

just picked up a dark thunder and drilled it up 10:30 pin under the fingers.  problem is that its rolling over my middle finger it doesn't have a X-hole in it yet... wondering where i would put the hole to move the track up/to the left so it doesn't roll over my middle finger any more.

not sure if this is needed
330RPM's
PAP 5 7/16 out 1" up
--------------------
Born a Lefty... Forced to become right handed...

Title: Re: Weight hole to move track
Post by: shelley on December 14, 2006, 01:55:56 PM

Low holes tend to move the track up.  That's the purpose of the hole placement in a Rico drill.  If you can spare the thumb weight, a hole in the positive thumb quadrant should do it.

SH

Title: Re: Weight hole to move track
Post by: tekneek on December 14, 2006, 07:39:48 PM

x-hole down the val 2-2 1/2" below the midline should move the bowtie up.
--------------------
Steve
Leading Edge Pro Shop
512-755-2947
e-mail tekneek@281.com

www.dynothane.com
D/T Customer Service 1-877-828-7177
Use option #1.

Capt Ramius "Vasili, give me one ping, and one ping only"