BallReviews
General Category => Drilling & Layouts => Topic started by: smash8-10split on January 14, 2005, 03:51:49 AM
-
what are the pin and cg placements on the (5x4)(4x4) ect ect....
What are label drillings and such? Label leverage?
--------------------
hold my hammer, while i NAIL your girlfriend.
Edited on 1/14/2005 12:52 PM
-
im still a little confused, say the 5x4 drilling, as long as the pin and cg are still 5 and 4 inches away could you use them on different spots on the ball, you said the pin would be over bridge, cg under ring, but could you use it as pin under bridge and cg kicked out or would that not be the 5x4 drilling?
--------------------
hold my hammer, while i NAIL your girlfriend.
-
quote:
im still a little confused, say the 5x4 drilling, as long as the pin and cg are still 5 and 4 inches away could you use them on different spots on the ball, you said the pin would be over bridge, cg under ring, but could you use it as pin under bridge and cg kicked out or would that not be the 5x4 drilling?
Yes. Any layout where the pin is 5" from the PAP and the CG is 4" from the PAP would qualify as a 5x4.
--------------------
"Dispensing conventional wisdom to a fingertip world."
Horrid in Doubles, torrid in Singles...
...that's The Curse of Dusty.
-
ok thanks guys, bob said what label was but what is label leverage??
--------------------
hold my hammer, while i NAIL your girlfriend.
-
label lev. = pin 3 3/8" from PAP and cg can be at or near the center of grip
--------------------
*Don't swing it if you can't bring it.*
-
quote:
ok thanks guys, bob said what label was but what is label leverage??
"Label leverage" typically describes layouts where the CG is at or near the grip center, with the pin at 3 3/8" from the PAP.
--------------------
"Dispensing conventional wisdom to a fingertip world."
Horrid in Doubles, torrid in Singles...
...that's The Curse of Dusty.
-
thanks a lot fellas
--------------------
hold my hammer, while i NAIL your girlfriend.