win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: RICO DRILL For a High Tracker (Will it Clip Fingers?)  (Read 1753 times)

Ramtart

  • Hero Member
  • *****
  • Posts: 1658
RICO DRILL For a High Tracker (Will it Clip Fingers?)
« on: December 23, 2005, 06:36:54 AM »
Ok, just curious. I track pretty high (Close to my middle finger and near edge of thumb).

PAP Coordinates: 5 1/2 > 5/8 ^

If I put the Rico Layout on a ball (symmetrical or asymmetrical) will I clip any of the finger holes?

Thanks!
Ram
--------------------
Regards, M.C. RAMmer
Official Jerry Rice Cabbage Patch Dancing Instructor
Logged

 

Goof1073

  • Hero Member
  • *****
  • Posts: 2433
Re: RICO DRILL For a High Tracker (Will it Clip Fingers?)
« Reply #1 on: December 23, 2005, 03:20:11 PM »
From my own experience...no!  I have a 5-1/2" x 1-3/8" PAP and I didn't have any issues with the two balls I drilled with a Rico.
--------------------
-Chris: DJ's Pro Shop : Auburn, MA
Logged

Slopsurprise

  • Hero Member
  • *****
  • Posts: 2100
Re: RICO DRILL For a High Tracker (Will it Clip Fingers?)
« Reply #2 on: December 23, 2005, 07:46:11 PM »
Whats a Rico drilling????
--------------------
Nothing hits like a Hammer!!

Yea.....nothing hits that bad!!!
Logged

shelley

  • Hero Member
  • *****
  • Posts: 9655
Re: RICO DRILL For a High Tracker (Will it Clip Fingers?)
« Reply #3 on: December 23, 2005, 08:23:46 PM »
quote:
Whats a Rico drilling????


Not this again!  

Basically, put the pin in the center of the grip and the CG at 4:30.  Drill a weight hole 6 3/4" from the pin through the CG (so in the very low thumb quadrant).  It's supposed to be a very smooth drilling with lots of midlane read.  It was very "in" last season since it was featured on Brunswick Insiders.  I don't know that the page is still there from last season.

SH
Logged

DP3

  • Hero Member
  • *****
  • Posts: 6093
Re: RICO DRILL For a High Tracker (Will it Clip Fingers?)
« Reply #4 on: December 24, 2005, 12:46:55 AM »
My rico drilled powergroove is actually pulling my track towards a full roller, and on shots I really get on it at the bottom, when the ball flares downlane it's thumping the thumbhole on the inside part of it.  I am thinking I may have to use a bigger deeper weighthole and not care about going past legal specs.  Any suggestions?
--------------------
-DP3
Respect the Game
Logged
Pages: [1]
« previous next »