BallReviews

Equipment Boards => Dyno-Thane => Topic started by: AllAirForceTwice on December 23, 2004, 01:02:16 PM

Title: Crisis Pearl Drilling Ideas
Post by: AllAirForceTwice on December 23, 2004, 01:02:16 PM

If someone could read my review of the Vendetta Pearl and give me an opinion on drilling The Crisis Pearl to compliment it I would appreciate it.

Also, has anyone thrown the Crisis Pearl on blown heads/track like the last game of a Sport League... What did it do?

Title: Re: Crisis Pearl Drilling Ideas
Post by: jimensminger on December 30, 2004, 06:08:58 AM

Dave,..I have a Crisis Pearl drilled with the pin above and to the right of the finger hole, cg is about 1/2" on the pos side of the midline on the midline. Surface was taken down with wet green scotch bright on a spinner, then came back with B'wick 800 factory polish to a good sheen. This ball is very smooth, and hard arcing, playing in when there's a burnt track. It doesn't jump off the dry,..which I really like. I changed the surface because the factory polish seemed to make the ball a little jerky. jim
--------------------
www.dynothane.com

Title: Re: Crisis Pearl Drilling Ideas
Post by: AllAirForceTwice on December 31, 2004, 02:10:53 PM

Thanks! I was hoping you had already experimented with changing the surface.

Title: Re: Crisis Pearl Drilling Ideas
Post by: jimensminger on December 31, 2004, 03:59:56 PM

call me crazy,..but only about 1 out of 3 balls I get from the factory get to keep their factory surface,...the Crisis Pearl surface (for me) was way too shiny...
--------------------
www.dynothane.com