BallReviews
Equipment Boards => Dyno-Thane => Topic started by: SrKegler on March 23, 2004, 06:54:12 PM
-
Quick question guys.
Pap 5 ¾ - ½ up, med speed, med revs.
Drilling up a Thing, 1†pin. Thinking of putting the pin below and centered on the bridge, CG kicked out in about a 10:30 drill.
What kind of reaction can I expect.
--------------------
~~~SrK - Have balls, will travel
1st law of combat, "Bullets always have the right of way"
-
for me I think I would get a long, smooth, medium arc in this drill, maybe a little roll out if the mids were too dry. With this short of a pin, I would drill this ball with the pin about 1/2" to 3/4" below the ring, and kick the cg about 1" to the right. Adjust with a weight hole after throwing if needed...
--------------------
je
-
Senior, your pap suggests that you have a high track, so I don't think you should put pin below fingers. You might track over your thumb hole, especially since that would be a low flare position. Try drilling pin out with ring finger hole and kicking out cg a tad.