win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Drilling a Thing  (Read 965 times)

SrKegler

  • Hero Member
  • *****
  • Posts: 3020
Drilling a Thing
« on: March 23, 2004, 06:54:12 PM »
Quick question guys.

Pap 5 ¾ - ½ up, med speed, med revs.

Drilling up a Thing, 1” pin.  Thinking of  putting the pin below and centered on the bridge, CG kicked out in about a 10:30 drill.

What kind of reaction can I expect.

--------------------
~~~SrK - Have balls, will travel

1st law of combat, "Bullets always have the right of way"
Logged
Have Balls - Will Travel


RIP Thongprincess/Sawbones

 

jimensminger

  • Hero Member
  • *****
  • Posts: 1846
Re: Drilling a Thing
« Reply #1 on: March 24, 2004, 10:37:43 AM »
for me I think I would get a long, smooth, medium arc in this drill, maybe a little roll out if the mids were too dry.  With this short of a pin, I would drill this ball with the pin about 1/2" to 3/4" below the ring, and kick the cg about 1" to the right. Adjust with a weight hole after throwing if needed...
--------------------
je
Logged

stringer

  • Sr. Member
  • ****
  • Posts: 294
Re: Drilling a Thing
« Reply #2 on: March 24, 2004, 04:07:47 PM »
Senior, your pap suggests that you have a high track, so I don't think you should put pin below fingers.  You might track over your thumb hole, especially since that would be a low flare position.  Try drilling pin out with ring finger hole and kicking out cg a tad.
Logged
Pages: [1]
« previous next »