BallReviews

Equipment Boards => Dyno-Thane => Topic started by: rbroller815 on April 20, 2007, 06:51:45 PM

Title: What can i expect
Post by: rbroller815 on April 20, 2007, 06:51:45 PM
what can i expect from an AU79 pin under cg kicked out. i have quite a few revs and a semi hi ball speed. just seeing how it will react
--------------------
**************************
Adam Carreon

Northern Illinois
University Bowling
**************************
Title: Re: What can i expect
Post by: rbroller815 on April 23, 2007, 02:04:09 AM
anyone
--------------------
**************************
Adam Carreon

Northern Illinois
University Bowling
**************************
Title: Re: What can i expect
Post by: newman891 on April 23, 2007, 03:51:50 AM
Put simply you can expect early and continuous roll through the pin deck.  I have a Hammer Hawg drilled pin below bridge with the cg kicked at 75 degrees.  If there isn't enough head oil, however, this ball burns and rolls out (making it hit like a sack...).
--------------------
Matthew R. Adams
Current Line-up:
Ebonite The One
Ebonite Angular One
Ebonite RXS 300
Ebonite Apex Aggression
D/T Vendetta Sniper

Coming soon:
Hammer No Mercy
Title: Re: What can i expect
Post by: charlest on April 23, 2007, 06:33:52 AM
quote:
what can i expect from an AU79 pin under cg kicked out. i have quite a few revs and a semi hi ball speed. just seeing how it will react
--------------------
**************************
Adam Carreon

Northern Illinois
University Bowling
**************************


This being a highly polished, half solid, half pearl ball, and your ball speed being on the high side, you might have to find a good deal of dry for it to make the turn. That drill sounds reasonable for your high speed, but a lot depends on where your PAP is and what the pin to PAP distance is. Also it being a soaker coverstock, they tended to hook slightly earlier than your average resin. The AU79 can tend to hook a lot due to its high flare potential, but unless you changed the surface, it was a medium oil ball IN GENERAL. It is also, IN GENERAL, not a skid/snap type of ball.
--------------------
"None are so blind as those who will not see."
Title: Re: What can i expect
Post by: rbroller815 on April 23, 2007, 01:16:00 PM
thanx for the replys anyone else
--------------------
**************************
Adam Carreon

Northern Illinois
University Bowling
**************************
Title: Re: What can i expect
Post by: rbroller815 on April 23, 2007, 06:36:34 PM
my pap is about 5 over and a quarter up
--------------------
**************************
Adam Carreon

Northern Illinois
University Bowling
**************************
Title: Re: What can i expect
Post by: BirwinJR on April 24, 2007, 12:14:02 AM
I have a AU79 with the pin under the middle finger and the CG at 45. It was a long pin so it put the CG next to the thumb it has a 1 1/32 WH. My pap is 5 1/2 over 1/4 up and after recently switching ball company's this will be the ball I miss the most. Dyno-thane nailed the name by calling this one GOLD! This ball with this type of layout just rolls great. I also have a higher speed and like the ball at a lower grit like 800 and below the some polish.
--------------------
www.rotogrip.com KING OF THEM ALL