Ebonite X-cel Particle:
Ball Specs
The ball being drilled was a 3†pin out with 3.00 oz top weight.
Drilling: Pin 4" from PAP and Mb 5" from PAP (approximately 60 degrees) pin is Above Ring finger, 3" above grip midline. Weight Hole 2" past my pap.
Bowler Information:
Track diameter is 10 1/2.
PAP is measured at 5 1/4 over and 3/8" up.
Average ball speed (foul line to head pin) is 17 mph.
Axis rotation is typically 90 degrees
Initial rev rate is typically 300 rpm, "Tweener"
Lane Condition and Pattern: Village Bowl in Memonomee Falls WI. Wood Lanes Oiled to 40 feet, semi-clean backends. Bowlero Lanes. HPL 9000 Panel. Oily up front, semi clean backends, carry down issues all year.
REVIEW:
This ball definately did not like the wood like center. Tended to spin up quick , hook early and does not make the turn on the back ends. On the HPL Panel, the ball reacted well, again, it spins up quick, it makes you look like you have 3-4 more revs on the ball. But if the ball encounters carrydown, it tends to lay off. I love the predictable roll, but it does not have the big boomming backends I was expecting. This would be a great ball for that freshly stripped backend shot where all if your other equipment is snapping to hard. Great ball for the spinner type of release because of it's earlier breakpoint and roll rate. Ebonite needs to improve the backend on this ball to make it a winner.
Compared to my other Balls:
Big Bully. The X-cel spins up quicker than the Big Bully, the Big Bully has more backend. Both I consider a smoother arching ball. The Big Bully out hooks the X-cel by 3-4 boards on the same pattern.
Thanks for reading my review.