Coverstock: Pearlized Big WheelTM Reactive Resin

Box Finish: 800 grit sanded, then factory polished

Color: Neon Blue/Neon Green

Core: Propeller Core, Asymmetric Design

PSA Location: 6-3/4" from pin

Mass Bias Strength: .004

Flare Potential: 6"+

Length: 16.80 (Ebonite’s scale of 1-30, early to late)

Overall Hook: 20.30 (Ebonite’s scale of 1-30, least to most)

Breakpoint Angle: 9.30 (Ebonite’s scale of 1-10, most smooth to most angular)

Best Lane Condition: Light to medium oil

2" pin

3 oz. top weight.

Drilled 12:00 with the CG right underneath my bridge. Polished to 2000 and finished with a coat of Elixir.

I bought this, and had it drilled, to be a snapping monster. I wanted maximum push with a strong flip and continuation. Will instead I got good length coupled with a lot of roll.

I can play almost any condition with this ball, and it will be predictable no matter what. While it does make a move, it's no where near as sharp as I expected, but this is by no means a bad thing. This ball sets up in the pocket, and does keep the pins low. The carry percentage is fairly high, but you don't see many messengers and you don't get a very rewarding crack at the pocket like you might expect.

Right now my warrior is my go-to ball when nothing else seems to be working, and I usually seem to pull my way out of a hole with it.

Good ball, but not truly great, equipment like this has existed before.

6/10
--------------------
Hey look! I can pretend I'm a Cali JR bowler!!

Representin' the Three-Six-Ohhh from Washington St. yo!

This ball is probably the worst Ebonite ball I have ever owned.  Didn't work well at all for my game.  Was drilled with pin near the ring finger with the cg kicked out and a weight hole to make it legal.  I couldn't get a consistent read with this ball.  Best of luck to all of you that are still using one.

I have 2 Warriors in my bag for tougher conditions where a consistent read is a plus and a certain specific reaction is required.

My first Warrior is layed out with a 4" pin to PAP placement, a 6" MB to PAP placement and a 57/64" weighthole drilled 2 1/2 inches deep on the PAP.  Pin height is 2 1/2" above the midline.  Starting topweight was 3oz.  Ball is at 800 grit.

I have about 40 games on this Warrior.  I chose to keep it dull because with my speed to rev-rotation ratio I need an earlier read because shooting the ball through the breakpoint is a problem for me.  Combined with an 800 surface grit, this Warrior gives me an early read with a smooth aggressive arc through the pocket.  I love using this in heavier fresh oils on more demanding conditions when free hook isn't available.  The low surface grit allows me to scribe a hook to the pocket while playing direct and after a game or two I have burned myself some free swing area in the midlanes.  This ball has also become my "get out of jail free card" when I am clueless to how to play the lanes.  Off the ditch with this piece gives me a great look and roll on a variety of conditions and surfaces.  The only problem is, too much dry will make this ball finish very weak.  That's usually my cue to go to Warrior #2.

My second Warrior is drilled with a drilling I saw on BrunswickInsiders.com that Tommy Jones and Patrick Allen used a majority of last season while throwing The One.  It is a pin placement of 5 1/2 inches to the PAP, with a pin height above the midline of 5 INCHES!  a Long pin was required for this layout so I went with a 4 1/2" pin out.  The MB was kept 1" below the midline(3 3/8ths from my PAP) and a 1" weighthole 3 1/4 inches deep was needed in the finger quadrant to give it a more forward roll motion off the breakpoint and to keep it within legal specs.  The ball was kept in it's OOB polish.  I have around 30 games on this ball.

From looking at the drill on this Warrior you'd think it'd go 50 ft and not move much but that's the complete opposite.  This ball revs up very heavy in the midlane around 35 feet and makes it's move toward the pocket on a more forward angle than your typical sideways motion.  It's almost reminiscent of a Urethane move on fresh shorter patterns.  I can see why Tommy Jones loves this layout because the control it gives off the breakpoint is definitely needed on patterns where there isn't much of a buff area at the end of the pattern which gives alot of balls a sideways move out of the end of the pattern.  This ball is also strong enough and more than capable of handling house patterns that have alot of friction to the right.  Since it's slower in response off of the dry, it goes where you throw it and is predictable out of the friction, which I love.  

The TPC Warrior and the propeller core is a favorite of mine, as the core is very versatile and gives you many options of breakpoint shape with different drills.  The cover(Big Wheel Pearl, also seen on the Savage Pearl) is also strong enough, yet versatile enough to take cover adjustments well and still be strong in today's thicker oils.  

Both of these balls will stay in my tournament bag for the upcoming season since they are so different from everything else I'm throwing.  They also allow me to play a comfort zone I am used to with predictability and strong hitting power.
--------------------
- DP3
Hoss Central Inc.
Respect the Game