I was able to throw this ball at the Ebonite Demo Day here in Brookpark, Ohio back in the middle of December. You can check my profile for my specs, but just know that I have good speed and a lot of hand.
All of the balls at Demo Day were drilled with the pin under the ring finger and the cg stacked below.
My first impression of the V2 Clean was that it is a tremendous ball. I got to throw this ball on 2 lanes with different volumes of oil. One lane was oiled heavily in the middle, with some dry bump outside of 5, and not much dry on the backend. The other lane was pretty much burnt up from earlier play on it.
On the oil lane, it would not turn up in the oil that much, but if I was straight enough through the heads with it, even in the oil, it would hit exceptionally well. Also, I was able to swing the V2 Clean from the oil to the dry bump, and snap it back to the hole with similarly fantastic results. So far, so great.
To make it even better, the V2 Clean was also tremendous on the burnt lane. As long as I was deep, and not projecting straight through the heads, but going left to right, I had great skid through the heads, rounding turn at the corner, and continuous sharp arc on the backend, with, once again, awesome hit.
Of all the balls I tested at Demo Day, I was most impressed by this ball. The versatility of this ball was amazing for me. I think the polished solid as opposed to a pearl cover make a large difference in this ball. It doesn't have over/under problems or too sharp breakpoints. It just could find a line on any condition for me. The straighter players tended to find this ball on the lower side of total hook, and could only use it on drier stuff. However, this ball is a crankers DREAM. Hook potential is medium, length is good (not VERY long), corner is round, backend is sharp arc (not snap), hit is tremendous. I have one being drilled now, and I am dying to get it. Great ball.