Part of me really wants to drill another one with a longer pin and a big shine on it.......It wouldn't be a pressing "need" but I think it would be a nice ball to have.

I only opted to pick one up because it cheap and was a good candidate for the Motion hole.  I think I have the surface adjusted to where it needs to be and the hole the correct size for the equation to work now.

I am cleaning it after every set with Power Wash and a gold pad... Not a lot of games at any set surface, so I don't have a good basis for coverstock "longevity" yet.

What size hole and what is the surface change?

1.125" x 4" hole... just changed the surface again.  What I have success with will likely be completely different from what you find fits your style.

Update,

Another guy in our house is a good level release up the backer(say 30 degrees axis rotation).

He likes strong stuff and ups his speed if too much.  I think he had a Jet Black Taboo.
He went to this pursuit and is TEARING it up as he said recently there had been more oil and a little less backend. 

His Pursuit S had a pin stronger drill than his Taboo also and was smooth and relentless going to the pocket.

I don't know about the durability.

Regards,

Luckylefty

The main ebonite ball junkie had one....never really dug it . Tried a few surfaces as well.  Everyone seemed to like the assymetical version too