win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: drilling the one  (Read 1564 times)

xratedbowler

  • Sr. Member
  • ****
  • Posts: 265
drilling the one
« on: November 10, 2005, 09:44:47 AM »
so bascially dont label drill it right? because thats my fav drill pattern, so go with something else looking at drilling sheet and see theirs another way to drill for long and strong frekin sweet!
--------------------
formely known as charles76


F.O.S 4 LIFE
(PLAYS AIR GUITAR TO MUSIC)!
Logged

 

Strider

  • Hero Member
  • *****
  • Posts: 6759
Re: drilling the one
« Reply #1 on: November 10, 2005, 05:55:41 PM »
Yep.  Looks like Ebonite tells you not to drill it with the pin near your ring, CG in the center of your grip, and the MB near your track.  Don't know why, but always follow the directions, especially with asymmetric cores.
--------------------
Penn State Proud

Ron Clifton's Bowling Tip Archive
Logged

dogmotta

  • Jr. Member
  • **
  • Posts: 54
Re: drilling the one
« Reply #2 on: November 10, 2005, 06:27:31 PM »
drilled mine according to spec sheet that came with ball. 45°.
Logged

jkiser01

  • Hero Member
  • *****
  • Posts: 7124
Re: drilling the one
« Reply #3 on: November 11, 2005, 12:34:15 PM »
I have my The One drilled like #3 on the drilling sheet and I am very satisfied with the reaction I get on the lanes..
--------------------
The Skins and the Cowboys are tied at 5-3, GO Skins!!

jkiser01
Logged
Radical Bowling Technologies ...Its more than just an Attitude!

xratedbowler

  • Sr. Member
  • ****
  • Posts: 265
Re: drilling the one
« Reply #4 on: November 11, 2005, 04:29:05 PM »
whats up with the high jacking dude? anyway thanks for the info going with drill pattern number 2 on the sheet!
--------------------
formally known as charles76
absolute inferno
the professonial
big block diesel
tsunami
the one

F.O.S 4 LIFE
(PLAYS AIR GUITAR TO MUSIC)!
Logged

Atochabsh

  • Hero Member
  • *****
  • Posts: 1467
Re: drilling the one
« Reply #5 on: November 11, 2005, 05:07:10 PM »
You could drill it label with the cg still in a label position but with some positive side weight so the bomb stays as near/below the thumb as possible. You could get the pin maybe 1:30 with the cg kicked out a bit. About 3/4 positive side weight. Strong label with a twist. Should be more arc-ing. A bit more controllable then leverage but still fairly strong. Most of the balls will have the pin/cg/bomb in a line, but I did see a few with "designer" placements. If you get one of these designer pin/cg/bomb placements then it could be very easy to drill it up just regular label for right or left hander depending on which direction the cg is off center.


Erin
Logged
Pages: [1]
« previous next »