BallReviews

Equipment Boards => Ebonite => Topic started by: TheMan14 on December 04, 2005, 11:05:27 PM

Title: How should I drill my Xxxcel
Post by: TheMan14 on December 04, 2005, 11:05:27 PM

I am going to use this for heavy oil.  Which layout should I use from the Ebonite drilling sheet for this ball?  I was looking into drilling #2, but any suggestions are welcome.  Thanks.
 
Drilling #2 (Earliest breakpoint, maximum hook potential in heavier oil)

Drilling #3 (Medium length, strong breakpoint)

Or put the pin 3 3/8" from my PAP and put the bomb at 45 degrees?

Title: Re: How should I drill my Xxxcel
Post by: BowlerKidR on December 05, 2005, 03:11:57 PM

u could put the pin 3 3/8 from pap and stick the MB(bomb) near ur axis for the early roll
--------------------
"Strike for show, spare for dough"
I LIKE TO BOWL
Im A Hammer Head 100%

Title: Re: How should I drill my Xxxcel
Post by: Tony Banks on December 05, 2005, 05:35:31 PM

I concur, early reaction is imperative for heavier oil. While the ball is designed to skate through the oil and react with a sharp angular break point keep in mind that Ebonite advertises that it reacts "earlier and stronger than the xxcel".