Author Topic: Drilling a Magic? (Read 1516 times)

Ebonite BowlToWin · « **on:** March 23, 2009, 12:37:32 PM »

How should I drill this to get the strongest reaction possible out of this?
Rev Rate: 350
Speed:17-19 mph
Style: Tweener

thumper · « **Reply #1 on:** March 23, 2009, 08:45:41 PM »

Pin above bridge or ring finger. Mass bias at 75 or 60 degrees. Have mine drilled pin above bridge, mass bias at 75 degrees, and it absolutely rips on the backend.

Ebonite BowlToWin · « **Reply #2 on:** March 23, 2009, 08:58:52 PM »

how many inches from PAP is yours drilled?

thumper · « **Reply #3 on:** March 23, 2009, 09:04:23 PM »

About 5 and a half inches. I get great length and a very angular backend (which is what this ball was designed to do). If the lanes get really tight, then I switch over to my NVD with a 4 and a half inch pin for more midlane.

Ebonite BowlToWin · « **Reply #4 on:** March 23, 2009, 09:12:01 PM »

Which do you use for heavier patterns? and what surface do you keep you magic?

thumper · « **Reply #5 on:** March 23, 2009, 09:14:52 PM »

I use the NVD for heavier oil (1000 grit). My Magic is at 4000 grit.

B Red · « **Reply #6 on:** March 24, 2009, 10:05:12 AM »

We had a guy in our company drill his Magic strong, 4 inch pin from axis. It didn't roll very well...

I drilled mine up 5 1/2 from axis and it rolls phenomenal. I believe you're pretty safe if you keep the pin 5 inches from axis.
--------------------
- Brandon Allred

08-09 UNLV Bowling Team
http://www.unlvbowling.org

K&K Bowling Services
"That's how we roll."
http://www.bowlinglasvegas.com
http://brandon@bowlinglasvegas.com

Author Topic: Drilling a Magic? (Read 1516 times)

Ebonite BowlToWin

Drilling a Magic?

thumper

Re: Drilling a Magic?

Ebonite BowlToWin

Re: Drilling a Magic?

thumper

Re: Drilling a Magic?

Ebonite BowlToWin

Re: Drilling a Magic?

thumper

Re: Drilling a Magic?

B Red

Re: Drilling a Magic?