win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: X-Out Question  (Read 2205 times)

storm making it rain

  • Hero Member
  • *****
  • Posts: 838
X-Out Question
« on: November 30, 2011, 01:51:42 AM »
Hello I just received a Mission 2.0 X-out.  How would lay this out for a lower tracker, high rev, high speed guy. (pin is 2") Below is a rough figue on how the markings are.

 

                                                  P

                                                       CG

 

 

MB( in the mission label)

 

thanks

 


Logged

 

Cobalt Bomb

  • Hero Member
  • *****
  • Posts: 2053
Re: X-Out Question
« Reply #1 on: November 30, 2011, 10:26:50 AM »
What is the topweight?


Logged

storm making it rain

  • Hero Member
  • *****
  • Posts: 838
Re: X-Out Question
« Reply #2 on: November 30, 2011, 10:32:20 AM »
4 3/4 oz


Logged

TWOHAND834

  • Hero Member
  • *****
  • Posts: 4357
Re: X-Out Question
« Reply #3 on: November 30, 2011, 10:38:58 AM »
Also, "low tracker" is kind of vague.  Any idea as to your actual axis point?  Reason being, is that if your horizontal measurement is 3.5-4 inches over, then you could put the pin at 5-5.5 inches from your axis and be able to drill the thumb hole pretty close to the MB and not need a weight hole, unless the top weight is pretty high.  Either way, you are probably going to need to drill your finger holes pretty deep if that cg marking is the correct cg.  Also, have the pro shop guy check to make sure that cg marking is the correct spot. 



Peace doesnt always have to be silent.
Logged
Steven Vance
Former Pro Shop Operator
Former Classic Products Assistant Manager

Cobalt Bomb

  • Hero Member
  • *****
  • Posts: 2053
Re: X-Out Question
« Reply #4 on: November 30, 2011, 11:54:07 AM »
Assuming the CG location is correct, that much topweight is going to make it tough. Without knowing your exact axis point, most likely your most realistic option will be to drill it pin under, perhaps under the middle finger or so, with the MB under the thumb. Drilling the fingers deep as well as a balance hole near the fingers will probably be necessary to get it legal.


Logged

storm making it rain

  • Hero Member
  • *****
  • Posts: 838
Re: X-Out Question
« Reply #5 on: November 30, 2011, 12:02:15 PM »
thats what i was thinking Cobalt. 

 

Thanks for the replies

 


Logged

Russell

  • Hero Member
  • *****
  • Posts: 5121
Re: X-Out Question
« Reply #6 on: December 04, 2011, 06:44:54 PM »
I would also try to spin that thing if you can.  I had a blem ball years ago that was out of line like that and the MB was horribly mismarked.  Just be safe.

Little known fact:  In Russian "Hope" and "Change" translate to "Tax" and "Spend"
Logged
Pages: [1]
« previous next »