Post by: Jeffrevs on December 22, 2005, 11:07:07 PM
Since there is a strong mass bias on this ball.....
Would there be a Morich 'control drill' equivalent for the One ? Like, 2 1/4 pin to pap and 6 7/8 from pap to mass bias....
http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTE2MTMzMTZzNDEzZGZkMzF5NTQx.jpg
There is nothing on Ebonite's site for a drill like this. I've also asked Ebonite, but I doubt I'll here antyhing quicky.
Any and all suggestions, please!
Thanks
--------------------
JEFF
"A Mayhem and a couple of Hercs.......uhm.....Nice!.."
Edited on 12/23/2005 8:51 AM
Post by: DP3 on December 23, 2005, 10:27:19 AM
--------------------
-DP3
Respect the Game
Post by: jls on December 23, 2005, 04:03:18 PM
they even go so far as to put a big do not drill this layout warning.
Post by: jls on December 23, 2005, 04:06:30 PM
however mo does not show a drilling on their seek and destroy near or in the track for the mb. they don't warn you not to, but they don't show a layout showing that drilling. storm does the same thing.
Post by: Jeffrevs on December 23, 2005, 08:57:05 PM
a 'control' drill.....if you look at the picture (and according to my specs) does NOT put the MB left of the thumb....it's low and down to the right a bit.....
--------------------
JEFF
"A Mayhem and a couple of Hercs.......uhm.....Nice!.."
Post by: Jeffrevs on December 23, 2005, 09:04:44 PM
I didn't want to ask you about this ball today because you were too busy when I left, but.......
what do you think of this ball ? And would it work (as we discussed) with a Morich control drill on it....w/ the proper surface of course
--------------------
JEFF
"A Mayhem and a couple of Hercs.......uhm.....Nice!.."