win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: V2 power drilling  (Read 1038 times)

bowlallthetime

  • Hero Member
  • *****
  • Posts: 673
V2 power drilling
« on: November 19, 2005, 09:35:21 AM »
I bought a new V2 power and I was looking at the drilling sheet.  I dont know my PAP.  will the driller be able to find out what it is if i give him a ball?  Any suggestions on how to drill it?  I want something very strong for heavy oil.  I have average ball speed and i'm a tweener.
Logged

 

azguy

  • Hero Member
  • *****
  • Posts: 8364
Re: V2 power drilling
« Reply #1 on: November 19, 2005, 06:42:26 PM »
I too agree, that you need to be careful in what you wish for...saying that, I will admit I have played around with a combo of the drill sheet.

I laid out my XXcel pin to the right of ring, approximately 4" from my PAP and MB right of thumb. I can play this with little adjustments on heavy to med conditions. It's my 'standard' drill now for most balls. But, I will say it's not worth much when you run into dryer conditions, so be careful what you want, it can come back to bite you...Just my 2 cents worth.
--------------------
AZ Guy aka: R & L Bowlers Pro
rlbowlerspro@cox.net
www.rlbowlerspro.com

Sleep is over rated.
Logged

bowlallthetime

  • Hero Member
  • *****
  • Posts: 673
Re: V2 power drilling
« Reply #2 on: November 19, 2005, 06:43:43 PM »
thanks for the info!
Logged

bowlallthetime

  • Hero Member
  • *****
  • Posts: 673
Re: V2 power drilling
« Reply #3 on: November 19, 2005, 07:15:34 PM »
so would a label drilling be good for this ball?
Logged
Pages: [1]
« previous next »