win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: The ONE drilling question: Technical  (Read 1876 times)

Jeffrevs

  • Hero Member
  • *****
  • Posts: 11890
The ONE drilling question: Technical
« on: December 22, 2005, 11:07:07 PM »
Hey all.....

Since there is a strong mass bias on this ball.....

Would there be a Morich 'control drill' equivalent for the One ? Like, 2 1/4 pin to pap and 6 7/8 from pap to mass bias....
http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTE2MTMzMTZzNDEzZGZkMzF5NTQx.jpg

There is nothing on Ebonite's site for a drill like this. I've also asked Ebonite, but I doubt I'll here antyhing quicky.

Any and all suggestions, please!

Thanks
--------------------
JEFF
"A Mayhem and a couple of Hercs.......uhm.....Nice!.."








Edited on 12/23/2005 8:51 AM
Logged

 

DP3

  • Hero Member
  • *****
  • Posts: 6093
Re: The ONE drilling question: Technical
« Reply #1 on: December 23, 2005, 10:27:19 AM »
I drill all assymetricals according to Mo's system and target hole practices.  Haven't had a problem or complaint yet.
--------------------
-DP3
Respect the Game
Logged

jls

  • Hero Member
  • *****
  • Posts: 18398
Re: The ONE drilling question: Technical
« Reply #2 on: December 23, 2005, 04:03:18 PM »
ebonite warns against drilling the mb left of the thumb, or near track.
they even go so far as to put a big do not drill this layout warning.
Logged

jls

  • Hero Member
  • *****
  • Posts: 18398
Re: The ONE drilling question: Technical
« Reply #3 on: December 23, 2005, 04:06:30 PM »
i agree with dp3,  to me,  mo is the henry ford of core designers.
however mo does not show a drilling on their seek and destroy near or in the track for the mb.  they don't warn you not to, but they don't show a layout showing that drilling. storm does the same thing.
Logged

Jeffrevs

  • Hero Member
  • *****
  • Posts: 11890
Re: The ONE drilling question: Technical
« Reply #4 on: December 23, 2005, 08:57:05 PM »
guys.....

a 'control' drill.....if you look at the picture (and according to my specs) does NOT put the MB left of the thumb....it's low and down to the right a bit.....
--------------------
JEFF
"A Mayhem and a couple of Hercs.......uhm.....Nice!.."
Logged

Jeffrevs

  • Hero Member
  • *****
  • Posts: 11890
Re: The ONE drilling question: Technical
« Reply #5 on: December 23, 2005, 09:04:44 PM »
hey king...long time no talk !!!

I didn't want to ask you about this ball today because you were too busy when I left, but.......

what do you think of this ball ?  And would it work (as we discussed) with a Morich control drill on it....w/ the proper surface of course
--------------------
JEFF
"A Mayhem and a couple of Hercs.......uhm.....Nice!.."
Logged
Pages: [1]
« previous next »