win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Total NV Drill Pattern #5 Question  (Read 911 times)

kodak

  • Jr. Member
  • **
  • Posts: 8
Total NV Drill Pattern #5 Question
« on: February 22, 2007, 03:18:29 AM »
I am drilling a Total NV this weekend. Typically, I use plastic and urethane at home due to a high rev rate and not alot of conditioner. The NV will be a tournament ball where more conditioner is typical.

I was thinking of drilling the ball with Drilling No. 5, the one Ebonite discourages due to a mild ball reaction.  I am looking for a mild reaction, but my concern is whether a ball with low flaring potential will hit the same as one with a maximum flare potential.

Has anyone drilled one this way?  If so, what were the results.

Thanks

Kodak
Logged

 

Cobalt Bomb

  • Hero Member
  • *****
  • Posts: 2053
Re: Total NV Drill Pattern #5 Question
« Reply #1 on: February 22, 2007, 01:39:56 PM »
I drilled an sr300 like that, very controllable arc, needs hooking back ends to carry, unless you have massive revs. Joe
Logged

Cobalt Bomb

  • Hero Member
  • *****
  • Posts: 2053
Re: Total NV Drill Pattern #5 Question
« Reply #2 on: February 22, 2007, 01:42:24 PM »
Sounds like you might like that Tommy Jones layout on the drill sheet. My son has one like that. Goes long with good recovery. Joe
Logged

strikemor

  • Jr. Member
  • **
  • Posts: 78
Re: Total NV Drill Pattern #5 Question
« Reply #3 on: February 22, 2007, 05:26:46 PM »
Definitely sounds like the Tommy Jones "trick drilling" would work well for you.
Logged
Pages: [1]
« previous next »