BallReviews
Equipment Boards => Ebonite => Topic started by: bowlallthetime on November 19, 2005, 09:35:21 AM
-
I bought a new V2 power and I was looking at the drilling sheet. I dont know my PAP. will the driller be able to find out what it is if i give him a ball? Any suggestions on how to drill it? I want something very strong for heavy oil. I have average ball speed and i'm a tweener.
-
I too agree, that you need to be careful in what you wish for...saying that, I will admit I have played around with a combo of the drill sheet.
I laid out my XXcel pin to the right of ring, approximately 4" from my PAP and MB right of thumb. I can play this with little adjustments on heavy to med conditions. It's my 'standard' drill now for most balls. But, I will say it's not worth much when you run into dryer conditions, so be careful what you want, it can come back to bite you...Just my 2 cents worth.
--------------------
AZ Guy aka: R & L Bowlers Pro
rlbowlerspro@cox.net
www.rlbowlerspro.com
Sleep is over rated.
-
thanks for the info!
-
so would a label drilling be good for this ball?