Author Topic: How should I drill my Xxxcel (Read 1055 times)

TheMan14 · « **on:** December 04, 2005, 11:05:27 PM »

I am going to use this for heavy oil. Which layout should I use from the Ebonite drilling sheet for this ball? I was looking into drilling #2, but any suggestions are welcome. Thanks.

Drilling #2 (Earliest breakpoint, maximum hook potential in heavier oil)

Drilling #3 (Medium length, strong breakpoint)

Or put the pin 3 3/8" from my PAP and put the bomb at 45 degrees?

BowlerKidR · « **Reply #1 on:** December 05, 2005, 03:11:57 PM »

u could put the pin 3 3/8 from pap and stick the MB(bomb) near ur axis for the early roll
--------------------
"Strike for show, spare for dough"
I LIKE TO BOWL

Im A Hammer Head 100%

Tony Banks · « **Reply #2 on:** December 05, 2005, 05:35:31 PM »

I concur, early reaction is imperative for heavier oil. While the ball is designed to skate through the oil and react with a sharp angular break point keep in mind that Ebonite advertises that it reacts "earlier and stronger than the xxcel".

Author Topic: How should I drill my Xxxcel (Read 1055 times)

TheMan14

How should I drill my Xxxcel

BowlerKidR

Re: How should I drill my Xxxcel

Tony Banks

Re: How should I drill my Xxxcel