BallReviews
Equipment Boards => Hammer => Topic started by: wpzone on April 24, 2007, 10:48:54 AM
-
Looking for suggestions on a layout for my wife. Dont know her specs, but she has low revs and low speed and uses 13lb equipment. This will be her heavy oil ball. I was thinking something like a 4" - 4 1/2" pin with a 45 - 60 degree MB. Any suggestions?
-
Since she has slow ball speed I would suggest placing the pin around 4.5" from her pap. A 60 degree MB location sounds like it would be a good choice. You could always adjust the cover if more bite is needed.
--------------------
HAMMER NO MERCY is Un-freaking real! Using this ball is like cheating!
-
I would highly recomend going with a 14#. If you go with 13, she won't be getting the Gas Mask Core.
-
I didnt know that, thought the 13's had the same core with Hammer. Do you know what core is in it? She is going to try a 14lb next week, found a used one a plugged it up, so we'll see how it goes. What companies are using the same cores in 13 as the heavier stuff. I know brunswick used to, and ebonite had some in the past.
-
Hammer uses the Diesel shaped core in their 13# equipment with an rg of 2.53 and differential of .055.
--------------------
LadyW....