Author Topic: BWP (Read 1255 times)

Monster Stitch · « **on:** August 10, 2007, 09:54:55 AM »

Hey guys. Any of you drill your Black Widow Pearl strong?

I currently have one pin over ring with the MB 2 inches right of thumb. I was
thinking of drilling one with the pin next to ring or over the ring again but with the MB further out to rev up a little quicker?

Will it still have the flip on the backend? Anyone also take the surface down and see it how it reacts in a heavier volume of oil?

Let me know.

--------------------
Team Banger Bowling Test Staff

Edited on 8/13/2007 0:42 AM

hardcorebowler · « **Reply #1 on:** August 10, 2007, 09:46:42 PM »

Mine is drilled stacked leverage with the pin about a 1.5" to 2" above the finger holes. It still gets through the heads easily and has flip on the backend

baseballfrk8998 · « **Reply #2 on:** August 11, 2007, 07:41:50 PM »

Mine is drilled to go long with a strong backend. The pin is 3-4" just above my ring finger and it has a very nice backend. I think it was the 4th or 5th drilling on that paper that comes with it, but it was modded a little bit.

bluerrpilot · « **Reply #3 on:** August 11, 2007, 09:31:41 PM »

quote:
Hey guys. Any of you drill your Black Widow Pearl strong?

I vurrently have one pin over ring with the MB 2 inches right of thumb. I was
thinking of drilling one with the pin next to ring or over the ring again but with the MB further out to rev up a little quicker?

Will it still have the flip on the backend? Anyone also take the surface down and see it how it reacts in a heavier volume of oil?

Let me know.

--------------------
Team Banger Bowling Test Staff

When you say "rev" up quiker, I assume you mean roll sooner. Putting the pin closer to your pap will make it roll sooner. Moving the MB out should make it more of an arcing motion. I dont think it will have as much "snap" in the backend that you want though.

Author Topic: BWP (Read 1255 times)

Monster Stitch

BWP

hardcorebowler

Re: BWP

baseballfrk8998

Re: BWP

bluerrpilot

Re: BWP