BallReviews

Equipment Boards => Hammer => Topic started by: jkiser01 on December 10, 2003, 04:40:15 AM

Title: Drill sheet for old blue hammers
Post by: jkiser01 on December 10, 2003, 04:40:15 AM

Does anyone have one of these laying around or know of a website where I can get the info to drill one of the old blue urethane hammers?

The pin is just above and to the right of the faball label on the ball. Can I just drill it basically "over the label" for a strong right hand drill?

If anyone has drilled up one of these and knows the strongest drill, please message me. I need some help.

thanks in advance..

jkiser01

Edited on 12/10/2003 8:41 PM

Title: Re: Drill sheet for old blue hammers
Post by: RandyO on December 10, 2003, 08:03:31 PM

That will work just fine. For a stronger drill just shift it a bit so that the cg is around 1/2 to 3/4 positive. That will put the pin a bit more out towards your leverage position (This dependes on your PAP measurment). With these classic Hammers, as long as the pin is outside of the Fab circle, drilling over the label is a good choice for a strong reaction.