I drilled a BWP with the pin position 3 3/4" above my midline, over the ring finger.  The pin is about 4" from my axis.  

I see quite a lot of lope in the midlane.  It is quite a bit more than I expected, even with having the factory surface at 4000 polished.

Would it be better to drill another BWP, drilling out the pin, in the ring finger (I love this layout on my BWS) or to try a surface change on the ball?  Should I knock the polish off and bring it to 2000?  Have you had more success with a polished or sanded surface?

I would appreciate opinions on this.

Thanks
Chuck