BallReviews
Equipment Boards => Hammer => Topic started by: ImaRedbird on February 02, 2006, 03:11:24 PM
-
Got a question. My B.Deal is not drilled agressive because it's supposed to be an aggresive ball already. It's drilled like this
-O--O---
---p----
---b----
---0----
--HMB---
p-pin
b-bomb
hmb-high mass bias
Ill try to get a pic uploaded. but im not sure if it's drilled strong enough. someone told me to NOT drill it strong otherwise it'll rollout. Was i right for doing that or should i re-drill it to be more aggressive?
--------------------
Stop Crying, Shut Up and BOWL!!! Everybody throws gutterballs back to back at one point in their life
Getting Zero is an accomplishent that you should be proud of!!!
-
tt
--------------------
Stop Crying, Shut Up and BOWL!!! Everybody throws gutterballs back to back at one point in their life
Getting Zero is an accomplishent that you should be proud of!!!
-
i would redrillit with the pin in similar location, but swing the HMB out closer to your PAP to get it into a roll.
--------------------
"Strike for show, spare for dough"
I LIKE TO BOWL

Im A Hammer Head 100%
-
I have one thats drilled pin under middle finger,cg twoards pap with a wt.hole below pap.this ball is a monster on heavy oil if I play up the boards with up the back release.clean up front,excellent mid lane set up and crushes the pocket.if I slow down a tuch the ball hits too hard and it usually leaves a nine pin.if I come around the side the ball will skate and not set up and when the oil gets thin the ball is to rolly and hits flat.so the big deal is very easy for me to figure out and read.hope this helps.
--------------------
I'm not bad,I just bowl that way.
-
thanks
--------------------
Stop Crying, Shut Up and BOWL!!! Everybody throws gutterballs back to back at one point in their life
Getting Zero is an accomplishent that you should be proud of!!!