win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Mass bias on a No Mercy  (Read 1148 times)

JPratt

  • Full Member
  • ***
  • Posts: 115
Mass bias on a No Mercy
« on: April 24, 2008, 03:12:30 AM »
I thought there was another post on this but was unable to find it.  How do you locate the actual mass bias on a No Mercy?
Logged

 

tenpinsniper

  • Jr. Member
  • **
  • Posts: 24
Re: Mass bias on a No Mercy
« Reply #1 on: April 24, 2008, 04:39:01 PM »
It is located 6 3/4 from the PIN and HART at 90 degrees. (The Dot in the HART is its locator pin.)

The No Mercy is a dual plane design meaning there is a Mass Bias on either side from this point. Just use what ever side benefits you most for your desired layout. Generally thought it not recommended to layout a No Mercy, not using the HART. Just remember even though your not using the HART I'd try to get it in the track. Maybe the bottom of the ball.

You might run you layout past someone at Hammer.
Logged

chitown

  • Hero Member
  • *****
  • Posts: 5876
Re: Mass bias on a No Mercy
« Reply #2 on: April 25, 2008, 08:40:28 AM »
The above post reply is correct.  

Draw a horizontal line starting at the HART and go 6 3/4" right, for a right hander.  Then draw another line from the pin to the end of the 6 3/4" horizontal line.  That's the actual MB.

I had a NM with the HART about 3" left of my thumb far into my ball track.  This would of put the actual MB close to the strong position.  This NM had a monster move on the backend.


Edited on 4/25/2008 11:01 AM
Logged

JPratt

  • Full Member
  • ***
  • Posts: 115
Re: Mass bias on a No Mercy
« Reply #3 on: April 25, 2008, 09:54:04 AM »
Thank you for the responses.
Logged
Pages: [1]
« previous next »