BallReviews
Equipment Boards => Hammer => Topic started by: northshoremb on January 14, 2007, 01:35:54 AM
-
Im getting a No Mercy and I have more speed then Revs but have Medium revs, and Im a semi-roller/high tracker from what people say (1.5"-0.5" from thumb to the odd time track hitting the thumb or finger but not often) On a shoter span ball track is as described without thumb problem but with a tad longer span I hit the thumb hole. Bowtie about 0.5"- 1" over middle finger to the left. I'm a tweener and dont know my axis rotation or such. I like the angular kick to the pocket and I would be using this ball for Medium to heavy oil pattern.
From what I described what drill pattern 1 or 7, and what pin and top weight should I order????
Thanx in advance.
-
northshoremb,
You will probably hear a lot of opinions on NM layouts. You'll have to read everyone's opinion and decide for yourself.
A 2-3 inch pin, 2-3 oz. topweight will offer plenty of drilling options. Either #1 or #7 should be OK, but #7 is supposed to be a high rev layout. I used layout #1 and it works great for me, and I'm medium revs with a high track. I think that the most important advice that I could give is to make sure that the Hart is within the first 3 rings of your ball track. I hope that this helps!
Edited on 1/14/2007 12:19 PM
-
TTT
-
If you are a high track palyer use a longer pin and keep pin even or higher than a line drawn across top of finger holes
-
I'm a high track lefty. I had #6 put on my No mercy after having #2 on it. It goes a little to long but is usable. If I had it to do all over again, I'd put #1 on it. For that I think you need a 4inch pin. 2cents.