win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Drilling two No Mercy Beat'ns  (Read 1051 times)

Nicanor

  • Hero Member
  • *****
  • Posts: 2292
Drilling two No Mercy Beat'ns
« on: August 07, 2007, 03:09:50 PM »
I have two NM Beat'ns on the way and would like to use them as a 1-2 ball with one of them being the first ball out of the bag and the other with a little more control but handling more oil.

I haven't seen the drill sheets yet and was hoping that someone already drilled several of these.

I know a lot of info is neded like PAP 4 7/8 and 5/8 up RH speed about 16.5 and medium rev rate.

Please ask more questions if it will help with the drilling recommendation.

Thank you.

--------------------
Nicanor (Ten On The Deck)
Logged
Nicanor (Ten On The Deck)

 

drw002

  • Full Member
  • ***
  • Posts: 115
Re: Drilling two No Mercy Beat'ns
« Reply #1 on: August 08, 2007, 05:40:44 AM »
i dont have a beat'n but i have a normal no mercy with the no4 drilling off the sheet and its a nice calm reaction so if u went for the no1 drill for a strong lay out then the no4 for a calmer reaction( may need to adust the surface on the no4 drilling to get the finish u want )
Logged

bluerrpilot

  • Hero Member
  • *****
  • Posts: 1235
Re: Drilling two No Mercy Beat'ns
« Reply #2 on: August 08, 2007, 10:42:55 AM »
I would drill them both with the #1 layout, but put the pin about 1" closer to pap on one of them. Then adjust the covers until you get the 1-2 combo you want.
Logged
Pages: [1]
« previous next »