BallReviews

Equipment Boards => Hammer => Topic started by: dev on October 26, 2004, 03:53:29 PM

Title: Saw Blade
Post by: dev on October 26, 2004, 03:53:29 PM

Anyone out there with a actual picture of it ?

Edited on 10/27/2004 7:42 PM

Title: Re: Saw Blade
Post by: jkiser01 on October 28, 2004, 06:53:26 AM

I have one drilled up and love it. if you send me your email address, I will send you a pic tonight.
--------------------
If they only made a ball that would carry that da_n 7 pin (and I am right handed!!)

jkiser01

Title: Re: Saw Blade
Post by: JPRLane1 on October 28, 2004, 09:13:23 AM

I saw one in person last night and it is sweet looking and it does look like the picture.  Hammer/Ebonite are doing great with the new ball colors with the exception of maybe a few.
--------------------
I should just quit bowling, oh wait I already tried that.
Now that I am back and my Saws are sharp again, I am ready to cut some wood.

Title: Re: Saw Blade
Post by: dev on October 28, 2004, 08:08:44 PM

The picture avaliable now look rather fake.. haha.

Title: Re: Saw Blade
Post by: craz_03 on October 28, 2004, 08:37:03 PM

yoz dev...
hahaaaahaa

Title: Re: Saw Blade
Post by: dev on October 29, 2004, 01:02:36 AM

hi ervin.. waiting for ya comeback onto the lanes

Title: Re: Saw Blade
Post by: wubowler on October 29, 2004, 03:16:51 PM

Drilled my saw blade pretty tame putting the pin above and to the left of middle finger(i am right handed), with the cg in the middle of my span.  With this drill the ball obviously goes long, like i wanted, but most impressively it reads the mid lane tremendously well.  Ball is very predictable at the breakpoint as I wasnt sure if it was going to be too much back end for me but the ball makes a nice transition to the pocket throwing pins everywhere.  Job well done by Hammer again with this ball.  Might ask for another one and drill maybe label to see the difference.

Billy D.
Hammer Amateur Staff

Title: Re: Saw Blade
Post by: dev on October 31, 2004, 06:05:20 PM

wubowler, thanks for the review. but what's the lane condition that you've tried on? Is the surface polished or dull ? What grit polish is it?

Title: Re: Saw Blade
Post by: wubowler on October 31, 2004, 07:20:25 PM

Bowled on both Old AMF Wood lanes on there last cut, ball had no problems getting down the lane.  And also on about 6-7 yr old synthetic lanes.  Again very clean.  Ball comes out of box polished at about 1000.  Pretty shine no extra polish is needed.