i would highly suggest a doom, toxic, or even a black widow.
it sounds like the big deal is starting its roll a little too early for the condition your bowling on co when you get it out, it doesnt have the strong recovery causing the weak tens.
a doom will be a little easier to read off the break point depending how you drill it. i am also a high rev player and this ball has definitely been working better for me with a pin down layout, something below the bridge specifically.
the toxic i have had a similar case with. Going pin up with it will cause a very clean through he heads reaction, but leaves the back end not as predictable.
with my toxic i have gone pin down with the cg kicked at a 45 degree angle with a balance hole to adjust the static weights. this ball still has a great backend motion and is still extremely clean through the heads.
so if you want an extremely strong backend motion i would say go for the toxic for sure. i have found i leave a lot of 9 pins and blower 7's due to the extreme entry angle however.
for the widow, if you wanted something solid that is still a snappy backend i would definitely invest in this ball. number one on the market and one of the most versatile balls i have ever thrown. if you put the pin above the fingers this ball is automatic money. keep the Mass Bias close to the thumb to get that snappier backend reaction. you could leave the ball out of box for the condition your bowling on and then adjust it with some factory finish powerhouse polish if necessary. this will be the most consistent reaction due to the solid coverstock hands down.
anyone of these three balls will definitely fit in between your two current bowling balls.
if you have any questions just pm me. more than happy to help
--------------------
Mason Sherman
Hammer Amateur Staff
"Nothing Hits Like A Hammer."
Talk is Cheap, Just Bring it...