BallReviews

Equipment Boards => Lane #1 => Topic started by: Ragnar on May 05, 2009, 09:31:07 AM

Title: Chainsaw Massacre
Post by: Ragnar on May 05, 2009, 09:31:07 AM
Just got back from throwing the Chainsaw Massacre.  I bought this to replace my ancient Silver Diamond (an original). Drilled with the CG out leverage layout (pretty much like my old silver). Started with 2 1/2 ounces tw, and a 3 inch pin (I'd hoped for a 4 inch like the silver, but this worked) Ain't science wonderful?  If I could overlay the two balls you would see exactly the same look from them.  I was on what was the house shot of 2 years ago, which basically was a 4 board shot for the old Silver.  Played right there with the CM and it was a killer.  Threw 18 in a row and quit.  This one's a keeper.
--------------------
"All I want to do is get my check and get drunk."
Title: Re: Chainsaw Massacre
Post by: Brickguy221 on May 05, 2009, 09:33:48 PM
Where did you place the Pin and where did you place the CG? I'm seriously thinking about one as soon as I get settled down from our move from our house in the country to a new house in town.
--------------------
"Whenever I feel the urge to exercise I lie down until the feeling passes away."

Brick
Title: Re: Chainsaw Massacre
Post by: AK47 on May 06, 2009, 09:46:32 AM
I too have a silver diamond and a chainsaw massacre... very similar, never thought i'd say that about another ball compared to the silver diamond.... the backend and carry for both of these balls is very, very good....
--------------------

CHAINSAW = MONEY
CHAINSAW MASSACRE = MORE MONEY






Title: Re: Chainsaw Massacre
Post by: Ragnar on May 06, 2009, 10:02:13 AM
Brick, pin is about 1/2" above bridge, centered.  CG is out at about 50 degrees (an inch and a half or so from grip midline - almost on the line from pin to pap.  Go to the Lane 1 site and find in the tech data the drill sheet.  It's the CG out leverage layout.)  I had to drill the fingers deeper than I normally do because of low top wt.  Otherwise the wt hole would have been very high.  I ended w/ 3/4 oz finger wt and almost no sidewt, needing a 3/4" hole about 1 1/4" deep on my pap.
--------------------
"All I want to do is get my check and get drunk."
Title: Re: Chainsaw Massacre
Post by: Brickguy221 on May 06, 2009, 12:39:58 PM
Thanks Bob....If I get one (which I want to) and with my lower revs,I may have to go Pin under Bridge since the ball has a low RG that is a bit on the high side and  a differential of .037. I'd have to talk to Chuck or T-God for advice.
--------------------
"Whenever I feel the urge to exercise I lie down until the feeling passes away."

Brick