BallReviews

Equipment Boards => Lane #1 => Topic started by: StrokerCT1 on March 06, 2005, 03:38:06 AM

Title: Hybrid DB CG & Pin Position
Post by: StrokerCT1 on March 06, 2005, 03:38:06 AM

I just bought a 16 lb Hybrid Dirty Bomb.  On Lane #1's drilling sheet
the pin is typically at the 12 o'clock position relative to the CG.  
(Directly Above). On this ball the pin is at about 12:30 relative to the
CG, above and somewhat to the right.  Does it make any difference ?
Lane #1's drilling sheet said the 12 o'clock position makes the ball driller
friendly for both left and right handed bowlers. Does the 12:30 position favor
a left or right handed bowler ?
Thanks !

Title: Re: Hybrid DB CG & Pin Position
Post by: StrokerCT1 on March 06, 2005, 01:45:33 PM

The ball is not drilled yet...

In the drill sheet for the ball (Pin is above) in 12 o'clock
position  

    pin

    cg


on this ball  (The pin is at 12:30 from the direction
pointed to by the CG.  Straight above the CG is to the
left of the pin

   pin

 cg

Title: Re: Hybrid DB CG & Pin Position
Post by: StrokerCT1 on March 06, 2005, 01:47:03 PM

The ball is not drilled yet...

In the drill sheet for the ball (Pin is above) in 12 o'clock
position  

pin

cg


on this ball  (The pin is at 12:30 from the direction
pointed to by the CG.  Straight above the CG is to the
left of the pin

x pin

cg

x is used to push the pin to the proper position

Title: Re: Hybrid DB CG & Pin Position
Post by: StrokerCT1 on March 06, 2005, 03:31:32 PM

Here it is,
thanks !!
http://pg.photos.yahoo.com/ph/john6054@sbcglobal.net/album?.dir=/bac7

Title: Re: Hybrid DB CG & Pin Position
Post by: scottie on March 06, 2005, 04:31:19 PM

pin under with cg out about 2 inches works great!

Title: Re: Hybrid DB CG & Pin Position
Post by: StrokerCT1 on March 06, 2005, 05:37:21 PM

http://www.imagehosting.us/?id=304233&type=viewpic

try this
thanks

Title: Re: Hybrid DB CG & Pin Position
Post by: StrokerCT1 on March 06, 2005, 09:08:11 PM

any thoughts ?
thanks

Title: Re: Hybrid DB CG & Pin Position
Post by: JPRLane1 on March 07, 2005, 12:05:21 PM

The logo and the CG are not to be confused.  The pin is always at 12 o'clock from the CG the logo may or may not be and usually isn't directly at 12 o'clock.  The cg is almost always in or near the label but I have seen them be outside of it.  Hope this helps the guy.  If your Cg isn't marked as I couldn't see it in the pic either then you need to have it found by your driller.
--------------------
Leader of Fellowship of the Saws! If its not a Buzzsaw it better be a Brunswick!
Come one, Come all but only if you wield the mighty Buzzsaw!
Honorary member of the almighty NATION!