BallReviews
Equipment Boards => Lane #1 => Topic started by: rymacatthedisco on February 01, 2008, 05:13:48 PM
-
so how should i drill the liberator, my pap is 4 1/2 over i throw bout 350 revs and about 17mph...just looking at wut everyone else is doing with theres
--------------------
RYAN MCDANIEL...Northern Illinois University bowling
www.newballz.com/forum
great new website!!!
FOS!!!
Diamonds...she'll pretty much HAVE to!!!
-
Mine Liberator checked in with a 2" pin.
I went with a basic label drill...pin just right of ring finger(3.75" from PAP), cg towards grip grip center. No weight hole required. This ball is quite a bit stronger than I imagined, yet it is silky smooth. Carry is very good. I tried it out on our usual THS...medium volume, dry outside 8, synthetic lanes. Playing a tight swing across ten, bumping the dry, the ball did not overreact. It changed direction very predictably and rolled up very nice.
A word of warning. This is not a dry lane ball...if the heads are toast, this sucker will hook off your hand!
Oh...one more thing...flat black bowling balls are dead sexy!
--------------------
Jon (in Ohio)
-
As Chris stated. It was my Liberator. I really liked the roll of this ball. Silky smooth is right on when describing this ball. There was a little too much oil for this ball but I wanted to throw it anyway. Shot 217 with a bucket/chop in the middle.
I had left with it but no right. Exactly what is expected from Urethane in this day and age.
Beans
--------------------
www.beansproshop.com
--------------------
Thomas "Beans" Biniek Jr.
PBA Member and Lane#1 Ball Drilling Expert
Thanks for reading and be sure to check us out at the Lane#1 booth in Albuquerque. Check out current eBay auctions at:
http://cgi6.ebay.com/ws/eBayISAPI.dll?ViewSellersOtherItems&userid=bowling_with_leah
Official Pro Shop of "ALL" F.O.S. Members!!!