Author Topic: Chainsaw Massacre (Read 984 times)

Ragnar · « **on:** May 05, 2009, 09:31:07 AM »

Just got back from throwing the Chainsaw Massacre. I bought this to replace my ancient Silver Diamond (an original). Drilled with the CG out leverage layout (pretty much like my old silver). Started with 2 1/2 ounces tw, and a 3 inch pin (I'd hoped for a 4 inch like the silver, but this worked) Ain't science wonderful? If I could overlay the two balls you would see exactly the same look from them. I was on what was the house shot of 2 years ago, which basically was a 4 board shot for the old Silver. Played right there with the CM and it was a killer. Threw 18 in a row and quit. This one's a keeper.
--------------------
"All I want to do is get my check and get drunk."

Brickguy221 · « **Reply #1 on:** May 05, 2009, 09:33:48 PM »

Where did you place the Pin and where did you place the CG? I'm seriously thinking about one as soon as I get settled down from our move from our house in the country to a new house in town.
--------------------
"Whenever I feel the urge to exercise I lie down until the feeling passes away."

Brick

AK47 · « **Reply #2 on:** May 06, 2009, 09:46:32 AM »

I too have a silver diamond and a chainsaw massacre... very similar, never thought i'd say that about another ball compared to the silver diamond.... the backend and carry for both of these balls is very, very good....
--------------------

CHAINSAW = MONEY
CHAINSAW MASSACRE = MORE MONEY

Ragnar · « **Reply #3 on:** May 06, 2009, 10:02:13 AM »

Brick, pin is about 1/2" above bridge, centered. CG is out at about 50 degrees (an inch and a half or so from grip midline - almost on the line from pin to pap. Go to the Lane 1 site and find in the tech data the drill sheet. It's the CG out leverage layout.) I had to drill the fingers deeper than I normally do because of low top wt. Otherwise the wt hole would have been very high. I ended w/ 3/4 oz finger wt and almost no sidewt, needing a 3/4" hole about 1 1/4" deep on my pap.
--------------------
"All I want to do is get my check and get drunk."

Brickguy221 · « **Reply #4 on:** May 06, 2009, 12:39:58 PM »

Thanks Bob....If I get one (which I want to) and with my lower revs,I may have to go Pin under Bridge since the ball has a low RG that is a bit on the high side and a differential of .037. I'd have to talk to Chuck or T-God for advice.
--------------------
"Whenever I feel the urge to exercise I lie down until the feeling passes away."

Brick