BallReviews

Equipment Boards => Lane #1 => Topic started by: Storm269 on February 26, 2007, 11:16:11 PM

Title: Question on G-force
Post by: Storm269 on February 26, 2007, 11:16:11 PM

Would like to know if the G-force is a good replacement for the Carbide plus..tks
--------------------
In my bag:
Carbide Plus
Enriched Uranium
Uranium HRG
Maxim Spare

Edited on 2/27/2007 8:13 AM

Title: Re: Question on G-force
Post by: Charles on February 27, 2007, 07:18:10 AM

It is supposed to be a stronger ball than the Carbide +.
--------------------
If you're not first, you're last!
Shake & Bake!

Title: Re: Question on G-force
Post by: Nicanor on February 27, 2007, 07:36:03 AM

I have both (@ G-Forces) one G-Force drilled very similar to the Carbide +.

The G-Force is a much better ball for oil then the Carbide +.  I didn't think the carbide + was a very good oil ball but a good medium oil ball.  If you keep the G-Force is box condition, it is a great oil ball.

I drilled one G-Force stacked leverage 3 #/8 and the other G-Force with the pin about one inch above the ring finger and the MB just to the right of the thumb as Doug recommended.  I think with a little polish on the G-Force with the pin over the ring finger and the other one close to box (box makes it too conditoin specific) that I will have a great one-two conbination.


--------------------
Nicanor (Ten On The Deck)

Title: Re: Question on G-force
Post by: novawagonmaster on February 27, 2007, 05:38:47 PM

I also have both.

I drilled the G-force label (pin slightly above finger line and right of ring, and MB about 3/4" left of thumb). I left it in OOB condition. It revs hard in the mids and is STRONG!

I first drilled my Carbide+ the same way. It was nowhere near as strong. I plugged the C+ and redrilled it CG axis. It is better, but still nowhere near as strong (in oil) as the G-force. The Carbide+ is better suited for medium with carry down (for me). On a heavy shot, the C+ will skate a bit, but the G-force is sweet.
--------------------
Jon (in Ohio)
CHROME WON'T GET YOU HOME!
F.O.S. Proud Saw user...see profile.

Title: Re: Question on G-force
Post by: zeusjr on February 27, 2007, 08:49:24 PM

I've got both as well and on my normal heavy oil wednesday night league the G-Force is about 8-10 boards stronger then my C+.  Both balls are drilled RICO, and I was trying the same line to see the difference...

Title: Re: Question on G-force
Post by: Storm269 on February 28, 2007, 10:28:45 PM

Thanks for all the replies...have just reserved a G-force..am thinking of drilling it the same as the Carbide plus...pin below ring and cg out with a balance hole. Will I be getting a similar ball reaction with this layout as compare to the Carbide plus ?
--------------------
In my bag:
Carbide Plus
Enriched Uranium
Uranium HRG
Maxim Spare