BallReviews

Equipment Boards => Lane #1 => Topic started by: WillynHook on November 29, 2005, 02:46:12 AM

Title: Uranium Pearl - Anyone alter the surface?
Post by: WillynHook on November 29, 2005, 02:46:12 AM

   Anyone taken to alter the surface of their Uranium Pearl
by sanding/scuffing it up? If so, what grit did you use and why?

Dr. Joe

--------------------
Dr. Joseph Howard
Joe's Physics Page (http://"http://faculty.salisbury.edu/%7Ejwhoward/")    

"Imagine what you could do,
if you could do what you imagine"

F.O.S. Member
Uranium Pearl
Bullet
Pearl Cherry/C^2
XXXL
Lane 1: 4 Ball Roller
Uranium Solid (expected order date ~Dec.)
More saber-toothed saws soon thereafter.
Hey! There is room in the roller!

Title: Re: Uranium Pearl - Anyone alter the surface?
Post by: absoluteisanidiot on November 29, 2005, 11:04:44 AM

I see that your waiting for the Solid Uranium I would not dull the surface of the Pearl as you will get a similiar reaction as the dull by doing so.

Title: Re: Uranium Pearl - Anyone alter the surface?
Post by: CORDOG on December 03, 2005, 05:02:42 PM

since Lane#1 uses Brunswick coverstocks they tend to take very well to surface alteration, unlike storm and ebonite coverstocks that i have come across.
--------------------
The Cyrness: Member -Fellowship of The Saws
Owner- Limestone Bowling Supply

Title: Re: Uranium Pearl - Anyone alter the surface?
Post by: scottie on December 03, 2005, 08:53:31 PM

you could try 1000 grit then buff to a sheen....a dull pearl usually will not work well and tend to roll out and die at the pins....
--------------------
www.sunsetstrip.com