Thank you for taking the time to read this post.
I drilled a Enriched Uranium and a Bullet the same way, pin over the ring finger and CG stacked. I drilled a Tsunami with the pin under the ring finger and CG in the strong position. I drilled the H2O with a 2:30 drilling or pin 2 inches from my PAP and the MB about 3/4 of an inch on the left side of the thumb. I know that there are many things to consider so far as ball speed, rev rate but for a bowler with 16.5 speed, 350 revs and tracks a little low PAP 4 7/8 and 5/8 up, all approximate, What difference and I going to see in the bowling balls. I know with any oil at all the Bullet goes straight looking for a dry spot to make a move, so the ball works well in light/dry conditions.
Hopefully someone is smarter then me and can actually understand my question.
On the H2O drill sheet I got the second diagram from the right on top states that the closer you move the pin toward the 3 O'clock position the more length the ball will have. I thought it was the complete opposite. Move the pin toward the top of the bridge for more length and a smoother earlier rolling ball with the pin getting closer to the 3 O'clock position.
Thank you.
--------------------
Nicanor (Ten On The Deck)
