Author Topic: what would this do? (Read 972 times)

Buzzhead · « **on:** January 04, 2004, 12:15:41 AM »

have a warped diamond core??

would this be assymetrical or what?

how may it roll??

could this be the new ball??

heres a rough pic.

IT WON'T FREAKING WORK!!!!!!!!!!!!!

basically a diamond with offset horizontal peaks.
........*......

.*........
..................*

.
.
.

........*......

hope it comes out like I typed it.

used preview and it is close but not what I wanted.
main thing to look at it the offset horizontal tips of the diamond.
if you put a mini D in the short end you would have a skid/flip monster right??
and if you put a mini D in the middle and have a even hooking ball or do I have
it backasswards?

--------------------
Saws are made to cut ANYTHING including 10 pins

Edited on 1/4/2004 6:47 PM

MI 2 AZ · « **Reply #1 on:** January 04, 2004, 04:27:38 PM »

Buzzhead,

Try drawing it again, but this time, press the pound button (#), 7th from the left. You should get the words 'code' in brackets. Put your cursor between them, hit the Enter key to move your cursor down one line, then start your drawing. When you are finished, your drawing should be between the 'code' in brackets and should turn out closer to what you want it to look like.
--------------------

I just want 2C was'zzub.
____________________________________

I am the SGT Schultz of bowling.
"I know nothing!"

Buzzhead · « **Reply #2 on:** January 04, 2004, 05:51:13 PM »

did not work try this on......

connect the * from top to right to bottom
to left in you mind and see what it looks like.

--------------------
Saws are made to cut ANYTHING including 10 pins

Author Topic: what would this do? (Read 972 times)

Buzzhead

what would this do?

MI 2 AZ

Re: what would this do?

Buzzhead

Re: what would this do?