BallReviews
Equipment Boards => Lane Masters => Topic started by: Laybzz74 on January 06, 2010, 08:50:25 AM
-
I have one with a 2 1/4" pin, laid out pin above on the gripline and the cg stacked what to plug and re drill it better, but not sure what to try to fully utilize this cover''s strengths. Suggestions and/or experiences ??
--------------------
**** Official "L/LM" ball "junkie" ****
http://www.lanemastersbowling.com
"Master the Lanes with Legendary hitting power" !!!
Robb in O Fallon, IL 62269 (near Scott AFB)
LAYBZZ74@AOL.COM (Email addy)
Edited on 1/6/2010 5:50 PM
-
I have one with the pin under the RG and the CG kick out 1 inch from the center line. I keep mine at 1000 abralon finish. The cover is mild for a solid reactive, but reads the mid lane and break point very consistently. Heavy rolling, hard hitting, and very predictable. No over under. A true bench mark ball that got very little love from the Lane Masters nation. I got 1 300 out of my XSP so far and flirted with two more . . .
-
Thanx ... anyone else ???
--------------------
**** Official "L/LM" ball "junkie" ****
http://www.lanemastersbowling.com
"Master the Lanes with Legendary hitting power" !!!
Robb in O Fallon, IL 62269 (near Scott AFB)
LAYBZZ74@AOL.COM (Email addy)
-
i am getting mine drilled as we speak. Going pin up 5 1/2 x 5. Don't know what to expect. I was afraid to drill it to strong with the high dif and low RG. If i still flare around 4.5-5 inches I should be alright.
--------------------
What is sandbagging???