Author Topic: Drilling and Layout Question (Read 1615 times)

Rival · « **on:** December 03, 2008, 07:46:39 PM »

I'm looking into laying out my own stuff, I've been reading and asking around a few questions picking up a little everywhere I can... but I have one that maybe one of you can answer. I understand a little bit of laying the ball out. Let's say I want to use a 4 x 4. I know this means 4 inches from the Pin to the PAP, and 4 inches from the Mass Bias to the PAP. You would want to draw a radius around the pin and the mass bias that is four inches for both, and where they intercept would be the spot for the PAP. What does a company mean when they say use a xx inch pin buffer? I'm not sure what they are talking about. Halp plz.
--------------------
"So there I was... BALLS DEEP!!!"

My Arsenal:

Storm Ace
Roto-Grip RSX
Ricochet Revenge
Total NV
Rival

novawagonmaster · « **Reply #16 on:** December 06, 2008, 10:29:34 AM »

That's the thing that goes "click-click...click-click...click-click" when you activate your directional siganls. It's called an alternator because it alternates between "light on" and "light off"

Author Topic: Drilling and Layout Question (Read 1615 times)

Rival

Drilling and Layout Question

novawagonmaster

Re: Drilling and Layout Question