I was wondering if any of you fellow BR'ers have any favorite layouts that you put on a your equipment.  If so, what are they?  Discuss why you use said layouts.

I've personally never had two balls laid out the same, wish I could find a couple layouts I can stick with.

Edited on 4/30/2009 5:58 AM

I like to use between 3.5-5 inch pin (depending on what ball i am drilling).
I usually use the same MB distance as my pin distance.

for a stronger drilling i will go for something like 3.5 X 3.5 + 1 15/16
for a weaker drilling i will usually go for 5 X 5 + 2 3/4
for my benchmark drilling i will normally use 4.25 X 4.25 + 2 5/16

If i were to fine tune the ball I will normally make surface alterations instead of weight holes but if i were to use a weight hole it would probably be on the stronger ball and past my axis by abour 2".

Edited on 5/2/2009 6:13 PM